Materials Handling Electrical power UNIT 1
Standard Description
This electrical power unit is created for the fork lift industry, consisting of really effective gear pump, DC motor, manual increase and lower valve, tank, ect. The up and down motion are managed from the lever of your guide release valve, that is outfitted with an 
electrical switch to activate the motor. The lowing velocity is controlled through the stress compensated movement control valve.
Specific Notes
one. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned prior to installation of the power unit.
3. Viscosity from the hydraulic oil shoud be 15~46 cst, which really should also be clean and free of impurities, N46 hydraulic oil is recommended .
4. Oil altering is required following the original 100 operation hrs, afterwards after each 3000 hours.
five. The power unit shown is created to be mounted horizontally.
Materials Dealing with Electrical power UNIT two
Standard Description
This energy unit features electrical power up gravity down circuit. Activate the begin solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve with the decreasing velocity managed by the strain compensated movement handle valve. Items of this series can be widely utilized in the industry of logistic gadgets such as fork lift, mini lift table, and so on.
Distinctive Notes
1. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all the hydraulic elements concerned just before mounting the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which must also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
four. Oil altering is required soon after the original one hundred operation hours,afterwards when every 3000 hours.
five. The electrical power unit must be mounted horizontally.