Electrical power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Common Description
This energy unit is developed solely to the small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been extensively utilised during the field of logistic devices for example minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is controlled through the solenoid valve together with the speed controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Basic Description
This electrical power unit is intended solely for your medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the velocity managed from the adjustable needle valve. When the lift rises to a large positoin, but the electrical power provide is lower, the lowering motion is managed through the manual override perform.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This electrical power unit is developed exclusively for that huge lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve plus the velocity managed by a strain compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This power unit is made solely for that big lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is cut, the lowering movement is controlled through the guide override perform.
Particular Notes
one. This energy unit is of S3 duty cycle, which could only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic parts concerned just before installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which should really also be clean and no cost of impurities.N46 hydraulic oil is suggested.
4. Oil transforming is required just after the first 100 operation hrs,afterwards when every 3000 hrs.
5. The electrical power unit proven is made to be mounted vertically.